Lutron Electronics Sivoia QS - System Configuration and Verification; Set EDU Limits

Press and hold the “open
limit button” ( ) for 5
seconds. The green LED on
the roller 64 EDU will flash
for 2 seconds, then go
dark, indicating that the
current position has been
stored as the open limit.
Adjust the position of the
EDU to the desired open
limit using the clockwise
and counterclockwise
buttons ( ).
Setting the open limit from the EDU
The open and close limits define the top and bottom of the shade, and are used to determine which
direction the shade must turn in order to raise or lower. Refer to the keypad’s instruction sheet to set
the limits remotely.
12
Setting limits from the EDU
Tap the “open limit button”
( ). The green LED on the
roller 64 EDU will turn on
steady, indicating that the
EDU is in “set open limit
mode.”
12.1
12.2
12.3
Steady LED
Tap the
Open Limit Button
Green LED
Tap the
open limit button
Use the clockwise
and counterclockwise
buttons to move the
EDU
Flashing green LED
Press and hold the
open limit button
for 5 seconds
Sivoia® QS roller 64TM Dual Mount Installation instructions
Page 14