24
OPERATORS MANUAL
STARTING WITH ELECTRIC STARTER
Checking and starting the cold engine as before.
To start engine, turn key to start position and hold. Holding key in
start position when engine has started could damage starter
mechanism. If engine does not start on first try, key must be turned
fully back to OFF each time. To stop engine, turn key to OFF position.
NOTE: Return the key by hand on very cold weather.
Do not hold key at start position more than 5 seconds. If the engine
wont start, wait 5 more seconds before trying again.
STOPPING THE ENGINE
Engine stops when the ignition key/the stop button is turned into
STOP-position or when the emergency switch lock is
pulled off or when the emergency switch on right handle is pushed
down.
GEAR SHIFTING WITH SYNCRO GEAR BOX
· Select the shift taking into consideration your driving; the 1st
gear gives the greatest pulling capacity; the 2nd gear gives
the highest speed. The gear positions you see in the below.
By the gear lever there is a tape indicating the gear positions.
When shifting gears from 1
st
to 2
nd
the speed limit is max 15
km/h. In order to shift from 2
nd
to 1
st
you have to
stop the snowmobile.
· Gearbox have no chain.
CHAINDRIVEN GEAR BOX
Chaindriven models have no gearbox, but you can buy as an extra
equipment the reverse gear. Snowmobile is capable of a fast reverse.
Driver should become familiar with this operation by practising on
To Next Page
Loading...
Need help?
General
