32
OPERATORS MANUAL
· Check that all the clips of the track are quite in order and are
not twisted. Check also that the plastic slide surface is not
too much worn out. A new slide surface is about 20 mm, it has
to be changed when it is worn out 8 mm in other words when
the thickness of the remaining slide surface is 12 mm.
· Check all suspension components for exessive play or wear
including ball joints, bushings, control arms, links, etc.
· Check visually all rear suspension components including slider
shoes, springs, wheels etc.
EMERGENCY STARTING
If the starter rope breaks or there is something else wrong with the
starter, the engine can be started with the emergency starter rope
as follows:
· Remove the starter and take into safekeeping the bolts.
· Fasten the starter handle on the emergency starter rope and
make on knot at the other end of the rope.
· Place the knot outside the wheel and wind up the rop through
the loop clockwise round the rope wheel.
· Start normally by pulling strongly from the rope.
WARNING! Watch out for the rope wheel!
NOTE: The tool kit which comes with the snowmobile includes the
emergency starter rope as well as all the tools needed for loosening
the starter. Do always have the tool kit with you.
Emergency starting can be done by winding up the rope on the
drive pulley.
To Next Page
Loading...
Need help?
General
