MacDon A30-D - Driveshields; Lift Cylinder Lock-Outs; Self-Propelled; Pull-Type

SECTION 7 MAINTENANCE AND SERVICING
Form 169000 / 169040 104 Revision D
7.4 DRIVESHIELDS
a. To open LH and RH driveshields on header,
press a screwdriver against latch in opening at
(A).
CAUTION
Ensure shield lock engages in the “open”
position as shown at (B) before letting go of
shield.
b. To close, push shield slightly farther open, and
move lock (B) out of the engagement slot. Lower
shield by hand, and release about 12 in.
(300 mm) from “fully closed” position. Shield will
self-latch.
c. To open driveline shield, disengage rubber latch
(C), and open shield (D).
d. To close, lower shield (D) and engage rubber
latch (C).
7.5 LIFT CYLINDER LOCK-OUTS
7.5.1 Self-Propelled
Refer to your Windrower Operator’s Manual.
7.5.2 Pull-Type
DANGER
To avoid bodily injury or death from
unexpected start-up or fall of raised
machine; stop engine, remove key and
engage lift cylinder lock-out valves before
going under machine for any reason.
a. Raise header fully, shut off engine, and remove
key.
b. Move handle to “horizontal” position on both
header lift cylinder lock-out valves.
C
D
A
B