SECTION 6 OPERATION
Form 169000 / 169040 97 Revision D
6.19 STORAGE
Do the following at the end of each operating
season:
a. Clean the header/mower conditioner thoroughly.
CAUTION
Never use gasoline, naphtha or any volatile
material for cleaning purposes. These
materials may be toxic and/or flammable.
CAUTION
Cover cutterbar and sickle guards to prevent
injury from accidental contact.
b. Store in a dry, protected place if possible. If
stored outside, always cover mower conditioner
with a waterproof canvas or other protective
material.
c. Raise header, and engage lift cylinder lock-outs.
d. If possible, “block up” the header to take weight
off tires.
e. Re-paint all worn or chipped painted surfaces to
prevent rust.
f. Loosen drive belts.
g. Lubricate header/mower conditioner thoroughly,
leaving excess grease on fittings to keep
moisture out of bearings. Apply grease to
exposed threads, cylinder rods and sliding
surfaces of components. Oil sickle components
to prevent rust.
h. Check for worn components, and repair.
i. Check for broken components and order
replacement from your Dealer. Attention to these
items right away will save time and effort at
beginning of next season.
j. Replace or tighten any missing or loose
hardware. Refer to Section 7.3.1 Recommended
Torques.
k. Remove divider rods (if equipped) to reduce
space required for inside storage.
To Next Page
Loading...
