SECTION 7 MAINTENANCE AND SERVICING
Form 169000 / 169040 172 Revision D
l. Adjust roll timing. Refer to Section 6.17.11.2
Roll Timing and Alignment.
m. Clean off excess sealant from motor flange and
gearbox face.
n. Apply light coat of silicone to motor flange, and
position motor on gearbox as shown until
mounting holes are aligned, and pinion engages
gear in gearbox.
o. Install bolts (U) and washers, and torque to
75 ft·lbf (102 N·m).
p. Re-connect hoses to motor.
q. Close all shields before operating machine.
To Next Page
Loading...
