UNLOADING AND ASSEMBLY
Form 169018 32 Revision C
STEP 11. LUBRICATE MACHINE
Recommended Lubricant
SPEC DESCRIPTION USE
SAE Multi-
Purpose
High Temp. Extreme
Pressure (EP2)
Performance With 1% Max
Molybdenum Disulphide
(NLGI Grade 2)
Lithium Base
As Required
Unless
Otherwise
Specified
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
f. Refer to the following illustrations for identifying
the various locations that require lubrication.
(continued next page)
To Next Page
Loading...
