UNLOADING AND ASSEMBLY
Form 169018 24 Revision C
B. HEADER ATTACHMENT - A SERIES
a. Remove hairpin from pin (A), and remove pin from
left and right header boots (B).
IMPORTANT
To prevent damage to the lift system
when lowering header lift linkages
without a header or weight box
attached to windrower, ensure that float
engagement pin is installed in storage
location (C), and not installed at hole
location (D).
CAUTION
Check to be sure all bystanders have cleared
the area.
b. Start engine, and activate HEADER DOWN switch
on the GSL to fully retract header lift cylinders.
c. Slowly drive windrower forward so that feet (E) on
windrower enter boots (B) on the header.
Continue to drive slowly forward until feet engage
the boots, and header nudges forward.
(continued next page)
E
B
D
C
B
A
HEADER UP
HEADER DOWN
To Next Page
Loading...
