MacDon M200 - Fuel Separator; Gear Box Lubricant Level; A;C Compressor Belt

PRE-DELIVERY CHECKS
Form 169018 43 Revision C
F. FUEL SEPARATOR
a. Place a container under filter drain.
b. Turn drain valve by hand 1½ to 2 turns counter
clockwise, until draining occurs.
c. Drain the filter sump of water and sediment until
clear fuel is visible. Clean as necessary.
d. Turn the valve clockwise to close the drain.
e. Safely dispose of fluid.
G. GEAR BOX LUBRICANT LEVEL
a. Remove plug. The lubricant should be visible
through the hole, or slightly running out.
b. Replace plug, and tighten.
H. A/C COMPRESSOR BELT
a. Tension on A/C compressor belt should be such
that a force of 8 to 12 lbf (35 - 55 N) deflects the
belt 3/16 inch (5 mm) at mid-span.
M200
M150