MAINTENANCE AN D SERVICING
NOTE:
Refer to Removing Cutterbar Spind le s, page 134 and Installing Cutterbar Spindles, page 136.
Change 13-foot (8 disc) spindle rotation from three crop-streams (C) to one crop stream (A).
1. Swap disc/spindle three and disc/spindle six.
Change 13-foot (8 disc) spindle rotation from three crop-streams (C) to two crop streams (B).
1. Swap disc/spindle three and disc/spindle four.
2. Swap disc/spindle five and disc/spindle six.
Change 13-foot (8 disc) spindle rotation from three crop-streams (C) to four crop streams (D).
1. Swap disc/spindle two and disc/spindle three.
2. Swap disc/spindle four and disc/spindle five.
3. Swap disc/spindle six and disc/spindle seven.
147910 143 Revision A
To Next Page
Loading...
