Indicators status is as follows.
HDMI/SDI IN
STATUS
REC
LIVE
Multiple indicators flash:
Indicators
On: input signal detected.
■
Breathing: input signal undetected.
■
On: The device has started and ready to work.
■
Off: The Device cannot start.
■
On: the encoder is recording to at least one destination.
■
Breathing: none of the rec sessions is enabled.
■
On: the encoder is streaming to at least one streaming address.
■
Breathing: none of the live sessions is enabled.
■
All but STATUS indicator lights flash once simultaneously: system is booting
up or rebooting.
■
The indicator lights flash in turn from HDMI IN, to Live : firmware is
updating.
■
If any other status appear, please try to unplug and re-plug in the
power cable to recover your encoder.
To Next Page
Loading...
