Magewell Ultra Encode AIO - Tutorial; Part 1. Ultra Encode Setup

Tutorial
Let’s learn by example.
Throughout this tutorial, we’ll walk you through the creation of a basic YouTube live streaming with Ultra Encode.
It’ll consist of two parts:
Part 1. Ultra Encode setup
Part 2. YouTube setup
Part 1. Ultra Encode Setup
1. Find Ultra Encode
1. Connect the encoder to a LAN and power it up.
2. Connect input signal.
3. Access Web UI:
Tap on the LCD touch screen of the device front panel until you see a QR code, scan the QR code, or type the IP address below the QR code into your web
browser.
Scanner (like smartphone) should be connected to the same local network as your device.
When the IP address shows 192.168.48.1, follow the steps below to join the device AP and access the Web UI.
i. Plug included Wi-Fi antenna when you want to connect to a wireless network.
ii. In your smartphone/tablet/laptop, turn on WLAN, search for and join the device AP named Ultra Encode + (Serial number).
The AP names after your gear's Serial number, and the password is the last 8-number of the serial number by default. For example, a serial number
313210101001 indicates the initial AP password is 10101001.
We recommend that the distance between the Web UI and the encoder should be within 10m.
iii. In your web browser, enter 192.168.48.1 to open the Web UI.
■
5