To Next PageTo Next PageWhy is my Magnescale LT20A counting wrong?
If your Magnescale Cash Counter displays erroneous counts, several factors could be at play. First, verify that the power voltage is within the specified range. Next, check if the unit occasionally miscounts. Finally, inspect for any mechanical issues that might compromise accuracy.
How to fix Magnescale Cash Counter if it will not turn on?
If your Magnescale Cash Counter is not turning on, try the following: Turn the power off, wait for one minute, and then turn it back on. Check the power line's connection and ensure its continuity. Verify that the power voltage is within the appropriate range.
What to do if I cannot obtain data after replacing the previous LT model on Magnescale Cash Counter?
If you're not getting data after replacing an older LT model with your Magnescale Cash Counter (using RS-232C output), ensure that the grounding is correctly set up.
How to improve accuracy of Magnescale LT20A?
If you are not getting accurate counts with your Magnescale Cash Counter, check if there's a significant temperature difference between the measuring unit, the machine, and the workpiece. Also, examine the machine adjustment or any deflection.
What to do if Magnescale LT20A is not counting?
If your Magnescale Cash Counter is not counting, switch off the power and then switch it back on after 5 seconds.
What to do if channel display is - on Magnescale LT20A Cash Counter?
If the channel display on your Magnescale Cash Counter shows '-', ensure that a correctly functioning measuring unit is connected and reset the device.
General| Brand | Magnescale |
|---|---|
| Model | LT20A Series |
| Category | Cash Counter |
| Language | English |
Explains warning symbols and their significance.
Instructions for connecting the counter unit to the measuring unit.
Steps for mounting the counter unit in a panel.
Details the front panel layout, buttons, and indicators.
Describes connectors and ports on the rear of the unit.
Guides through initial setup procedures upon first use.
Covers display, resolution, and reference point setup.
Specific initial settings for BCD output models.
Specific initial settings for RS-232C communication models.
Step-by-step guide to setting preset values.
How to select measurement modes like current, max, min.
Instructions for setting upper and lower limits for comparison.
