Magnetek Flex M - Power Supply Module - Gen 1

Flex M Engineered Receiver Instruction Manual
May 2019
Page 20 of 50
4.3 POWER SUPPLY MODULE – GEN 1
This section is applicable to the following power supply module part number(s):
• 25-02-074-804E (120VAC 60Hz 15VA, 1000mA)
• 25-02-074-810E (9-18VDC @1.5A 25VA, 1500mA) – No longer available
• 25-02-074-820E (9-36VDC 15VA, 1000mA)
Identifying a GEN1 Power Supply module:
• The module will contain a label with one of the part numbers listed above
• The LED overlay decal will be black
The Flex M power supply module converts the supply power to 5VDC power for all the attached Flex M
modules. This power module has a maximum output supply current of 1000mA. There is one power
supply module in the Flex M system.
Figure 10. GEN1 Power Supply Module Detail View
Figure 11. GEN1 Power Supply VAC Wiring Figure 12. GEN1 Power Supply VDC Wiring
NOTES:
1. Although the power module has built-in protection, Magnetek strongly recommends the use of
external fuses and circuit disconnects for all Flex modules.
2. The built-in fuse is not user serviceable but can be checked if troubleshooting. To check the fuse,
remove the power module from the din rail as described in Section 3.9. The fuse location is
shown in Figure 10. Use a multimeter to check for continuity across the fuse. If the fuse is blown,
contact Magnetek to send the module in for service.