MHR Radio Controller Instruction Manual
June 2017
Page 36 of 58
4.0 NORMAL OPERATION
WARNING
PRIOR TO OPERATING EQUIPMENT WITH THIS RADIO CONTROL SYSTEM, THE EQUIPMENT BEING
CONTROLLED SHOULD BE INSPECTED FOR ANY DAMAGE. DO NOT OPERATE DAMAGED
EQUIPMENT. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH
AND DAMAGE TO EQUIPMENT.
When starting up the MHR in the normal operation mode, the MHR will cycle through a few start-
up screens before going to the normal operation screen.
4.1 INITIALIZATION
During normal operation start-up, the MHR will initialize and provide its status for operation.
Figure 17: MHR Version Info Screen
Version Info: The first start-up screen is the Version Info screen. This screen displays the
installed software versions of Project Code, Common Code, and Display software. These are
needed if requesting help from the Magnetek Service Center.
Figure 18: MHR Access Code and Channel
To Next Page
