MHR Radio Controller Instruction Manual
June 2017
Page 45 of 58
6.3 2.4 GHz: FHSS
Channel hop sequences are designated between 1 and 32. The frequency range is between
2402-2478 MHz. The frequency hopping protocol does not use one particular frequency to
transmit a message. Messages are transmitted over multiple frequencies in a predefined
sequence or channel set. In doing so, this protocol is able to compensate for interference that
may be present on a single frequency by sending the message across multiple frequencies.
6.4 FCC STATEMENTS
Compliance Statement (Part 15.19)
This device complies with Part 15 of FCC
rules.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any
interference received, including
interference that may cause
undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly
approved by the party responsible for
compliance should void the user’s
authority to operate the equipment.
This portable transmitter with its antenna
complies with FCC’s RF exposure limits
for general population/uncontrolled
exposure.
To Next Page
