BE 58-602 Pulsar
®
Model R96 Radar Transmitter
To utilize the QuickStart menu available on the
PULSAR Model R96, some key information is required
for configuration.
Gather the information and complete the following operating
parameters table before beginning configuration.
NOTES: The QuickStart menu is available for Level Only applications.
1. Refer to Section 2.6.5 for configuration menus for Volume
applications.
2. These configuration steps are not necessary if the transmitter
was pre-configured prior to shipment.
Level What units of measurement will be
Units used? _____________
Tank What is the tank height? _____________
Height
Antenna What type of antenna is being used?
Model Select first 7 digits of Model number.
(See nameplate on side of antenna) _____________
Antenna What is maximum nozzle length for
Extension which the antenna can be used?
Select last 3 digits of Model number.
(See nameplate on side of antenna) _____________
Antenna Is the antenna mounting NPT, BSP,
Mount or flanged? _____________
Dielectric What is the dielectric of the process
medium? _____________
4 mA What is the 0% reference point for the
Setpoint 4.0 mA value? _____________
(LRV)
20 mA What is the 100% reference point for
Setpoint the 20.0 mA value? _____________
(URV)
PV Alarm What output current is desired when a
Selection failure indicator is present? _____________
To Next Page
Loading...
Need help?
General
