Mahe MMS 2000P - Filler Wire Material Selection; MIG;MAG Welding Type Selection; Welding Mode Selection; Manual Wire Inching; Welding Process Selection

MMS 2000P
MMS 2400
MMS 3000 13
EN
4.2.2. Welding mode selection / Manual wire inching
(Not available if MMA/TIG selected)
- Two cycle mode
- four cycle mode
- Manual wire inch mode. In wire speed window is possible to
adjust the speed for manual feed. Feeding is activated by
pressing the trigger button.
4.2.3. Welding process selection
- MIG/MAG process
- MMA welding process
-TIG welding with Lift Arc ignition
4.2.4. MIG/MAG welding type selection
(Not available if MMA/TIG selected)
- Standard MIG/MAG welding
- Pulsed MIG welding
- MIG Double Pulse
YPER
ULSE
H
P
- Hyper Pulse
YPER
ORCE
H
F
- Hyper Force
YPER
OLD
H
C
- Hyper Cold
4.2.5. Filler wire material selection
(Not available if MMA/TIG selected)
FeSg2 - Standard, not alloyed steel, shielding gas: 82%Ar + 18%CO
2
FeSg2 - Standard, not alloyed steel, shielding gas: 100%CO
2
308LSi - Stainless steel AWS308LSi, gas: 97.5%Ar + 2.5%CO
2
316LSi - Stainless steel AWS316LSi, gas: 97.5%Ar + 2.5%CO
2
309LSi - Stainless steel AWS316LSi, gas: 97.5%Ar + 2.5%CO
2
AlMg5 - Aluminum + 5% magnesium, shielding gas: 100%Ar
AlSi5 - Aluminum + 5% silicium, shielding gas: 100%Ar
AlSi12 - Aluminum + 5% silicium, shielding gas: 100%Ar
CuSi3 - Copper silicium wire, shielding gas: 100%Ar
CuAl5 - Copper bronze wire, shielding gas: 100%Ar
SPEC1 – Custom specific wire (in case of special request)
SPEC2 – Custom specific wire (in case of special request)
YPER
OLD
H
C
YPER
ULSE
H
P
YPER
ORCE
H
F