Mahe MMS 2000P - Filler Wire Material Selection; Operating Panel Ecomig; Ecopulse; Welding Mode Selection; Manual Wire Inching; Welding Process Selection

18 MMS 2000P
MMS 2400
MMS 3000
EN
4.3. Operating Panel EcoMIG / EcoPulse
4.3.1. Welding mode selection / Manual wire inching
(Not available if MMA/TIG selected)
- Two cycle mode
- four cycle mode
- Manual wire inch mode. In wire speed window is possible to
adjust the speed for manual feed. Feeding is activated by
pressing the trigger button.
4.3.2. Welding process selection
- Standard MIG/MAG welding process
- Pulsed MIG welding process (EcoPulse only)
- Double Puls process (EcoPulse only)
YPER
ORCE
H
F
- Hyper Force process
- MMA welding process
- TIG welding with Lift Arc ignition
4.3.3. Filler wire material selection
(Not available if MMA/TIG selected)
Fe - Standard, not alloyed steel, shielding gas: 82%Ar + 18%CO
2