4.3.6. Set up, adjustment and display description
Welding power set up synergic mode
MMS machines are controlled with full synergic feature
(except Manual modus). The welding power is to adjust just
with one main rotary encoder. By press of the encoder button,
wire speed (in meters/min) or material thickness (in
millimeters) can be selected.
In MMA and TIG mode is only Ampere setup possible.
Arc length correction synergic mode
In all MIG/MAG modes is possible to adjust length of the
welding arc. By turning the encoder in any direction is
display switching from Voltage mode to Arc length correction
mode (% LED active).
Arc length set to 0
Arc length set to +30
Arc length set to –30
Arc length correction is not available in MMA and TIG
welding.
Voltage correction synergic mode
By pressing the encoder button for 2sec, the voltage value
start to flash and welding voltage can be corrected. Note,
after material thickness change or wire speed change will be
welding voltage automatically reset to factory value.
To Next Page
Loading...
