MAJORITY OAK-CDAB-WAL - Technical Specifications; Warranty; Troubleshooting Guide

Power supply:
Mode:
Output Connector:
Aerial:
AC 200-240V 50/60Hz
FM(87.5MHz – 108MHz
DAB
/DAB+ 174-240MHz
Earphone jack
Integral telescopic aerial
Power Supply and Batteries
The unit is powered and charged by UK Standard Plug.
Technical Specicaon
Warranty
All products come with a standard 12 month warranty. All
items must be registered on
for the warranty to be valid. Once on the web page, use
the menu to find “ register your product”.
You will also be given the chance to extend your
warranty for an additional 24 months, free of charge.
Troubleshoong Guide
No sound
Buttons are not working
FM: Static sound
DAB: Burbling/
intermittent cut-out
Sound is distorted
Desired station not found
Display shows
“No Service”
Display is blank
Time and Date not setting
automatically
The station is not tuned in. Fine tune the station.
The volume is set to a low position. Increase the volume.
Headphones may be connected. Disconnect the
headphones.
Turn o the unit and turn on after a few seconds.
Signal reception is low. Adjust the aerial or move the unit to a stonger signal
location.
Re-scan stations.
The volume is too high. Adjust the volume control.
Weak signal. Use the manual tune function.
There is no DAB coverage in your area, or poor reception. Adjust the position of
the aerial, or move the unit to a stronger signal location.
This may occur if the broadcaster changes the label of a service or removes a
label while tuned. The radio will try to retune or perform a scan.
For the time and date to set automatically you need to turn on the system and
switch to DAB radio and let this scan. Then press the ‘Power Mode’ button and
the system will go into standby. The date and clock will update
automatically.
Observaon Potenal cause/soluon
Instrucons Guide
15