Makita HR2610T Technical Information

P 10/ 23
[3] DISASSEMBLY/ASSEMBLY
[3]-1B. Holder section for Drill chuck for HR2310T
DISASSEMBLING
(1) Remove Tool holder set from Tool holder guide complete. (Fig. 7)
(2) Remove Cap 35, then separate Ring spring 19 from the groove of Tool holder using 1R003 with 1R212. (Fig. 8)
(3) Remove Chuck cover, then remove Steel ball 7.0 while pressing down Stopper. (Fig. 9)
Stopper, Guide washer, Conical compression spring 21-29 and Flat washer 21 are removed. (Fig. 10)
(4) Remove Ring spring 21 with 1R004 from Tool holder guide complete side.
Flat washer 24, Leaf spring and Steel ball 5 are removed. (Fig. 11)
(5) Remove two Steel balls 6, Torsion spring 31and Change ring from Tool holder.(Fig. 12)
Fig. 7
Chuck cover
Steel ball 7.0
Stopper
Chuck cover
Groove of
Tool holder
Cap 35
Ring spring 19
1R003
1R212
Torsion spring 31
Change ring
Steel ball 6
(2 pcs.)
Tool holder
Change cover
Fig. 10 Fig. 12Fig. 11
Fig. 8 Fig. 9
Repair
Tool holder
Tool holder
guide
complete
side
Stopper
Guide washer
Tool holder
Flat washer 21
Conical
compression
spring 21-29
Ring spring 21
Flat washer 24
Leaf spring
Steel ball 5
Tool holder guide
complete
Tool holder set
Tool holder set

Makita HR2610T Specifications

General

Brand	Makita
Model	HR2610T
Category	Rotary Hammer
Language	English