Makita LD080PI - Calibration; Calibration of tilt sensor (Tilt Calibration)

Makita LD080PI
15
EN
Calibration
Calibration of tilt sensor (Tilt Calibration)
1
2 sec
simultane-
ously
2
Place device on absolutely flat sur-
face.
3
180°
4
Turn the device horizontally by 180°
and place it again on absolutely flat
surface.
5
6
Turn the device and place it again on ab-
solutely flat surface.
7
180°
8
Turn the device horizontally by 180°
and place it again on absolutely flat
surface.
9
i
After 2 sec
the device
goes back
to the nor-
mal mode.