Makita RT0701C - When Using as a Router Only with a Plunge Base (Optional Accessory); Plunge Base (Optional Accessory)

11 ENGLISH
1
2
3
4
► 1. Bar type grip (optional accessory) 2. Grip attach-
ment (optional accessory) 3. Offset base plate
4. Trimmer base assembly (optional accessory)
Mount the trimmer base with four screws and the grip
attachment (optional accessory) with two screws on the
offset base plate.
Screw a bar type grip (optional accessory) onto the grip
attachment.
1
2
3
► 1. Screw 2. Knob type grip 3. Offset base plate
In another way of use, the knob type grip which is
removed from a plunge base (optional accessory) can
be installed on the grip attachment. To install the knob
type grip, place it on the grip attachment and secure it
with a screw.
When using as a router only with a
plunge base (optional accessory)
CAUTION:
• When using as a router, hold the tool rmly with
both hands.
1
2
► 1. Plunge base 2. Grip
To use the tool as a router, install the tool on a plunge
base (optional accessory) by pressing it down fully.
Either knob type grip or bar type grip (optional acces-
sory) can be used according to your work.
1
2
► 1. Screw 2. Knob
To use the bar type grip (optional accessory), loosen the
screw and remove the knob type grip.
1
► 1. Bar type grip (optional accessory)
And then screw the bar type grip on the base.