Spray measurements
Component Location Materials
Sample area Internal surfaces. Glass (lenses).
Anodised aluminum.
Two-pack polyester paint.
Stainless steel.
All spray measurements should be extracted to the outside of the building.
However, some material may settle out onto the surfaces of the sample area. If
this happens the area should be cleaned immediately.
As an additional caution the paint finish of the external covers may be
permanently damaged if samples or dispersants are spilt onto them. Any spillage
must be scrupulously cleaned up immediately.
Remember to check the chemical compatibility of your sample accessories before
using a new sample and dispersant.
APPENDIX B
Getting Started
Page B.2
MAN 0101
To Next Page
Loading...
Need help?
General
