Introduction
The manual so far has taken you through the individual steps of making a
measurement and processing the data. This has allowed you to understand the
individual processes involved. In practice however you would most probably set
up the whole measurement sequence as a semi-automatic process.
Setting up a sequence
A sequence is set up through the Setup-Measurement Sequence menu item.
The Measurement sequence dialogue is shown below.
From this dialogue you can select the measurement procedures you require. You
have the option of running more than one measurement by increasing the
Number of Measurements edit box. A delay can also be set in between the
measurements. This is useful, for example, if you wish to automatically measure
the same sample over a period of time.
Once you have set up the measurement details you can set the way the
measurement data will be analysed by pressing the Process Sequence Setup
button À. The dialogue below will appear.
1
2
ILL 1876
The
Measurement
Sequence
dialogue can
also be selected by
pressing the
Setup
Sequence
button.
NOTE
'
CHAPTER 8
GETTING STARTED
Page 8.1
To Next Page
Loading...
Need help?
General
