Statement of LVD compliance
The CE badge on this product signifies conformance to European Commission
Directive 72/23/EEC the Low-Voltage Directive as amended by Directive
93/68/EEC the CE Marking Directive. The directive has been satisfied for
Malvern equipment by applying BS EN 61010-1 :1993 Safety requirements for
electrical equipment for measurement, control, and laboratory use Part 1 -
General requirements.
Statement of EMC performance for the
Mastersizer S
The CE-badge on this product signifies conformance with the protection
requirements of the European EMC directive, (89/336/EEC).
The following statement of EMC performance refers to the Mastersizer S system
as defined below operating under the following test conditions.
Equipment under test
Equipment Model
Mastersizer S MSS
Support equipment:
NEC PowerMate 386/33i PM-530-2421
VDU APC-H5340
Kbd APC-HH122
Mouse M\N M-SE9-6MD
Test conditions
The Mastersizer S is a particle size measurement instrument, controlled and
operated from a computer. The particles are presented in a suitable medium
within a test cell through which a laser beam is focused. The diffraction pattern
produced by the particles is measured and from the result the size of the particles
is calculated.
APPENDIX G
GETTING STARTED
Page G.1
To Next Page
Loading...
Need help?
General
