Mamiya DSX - Replacing

E=-1 Replacing TL2 Governor New type
Governor can be removed without removing
mirror housing assembly due to the
modification of mirror housing assembly.
Governor can be removed after removing
Bottom cover and 2 pieces of PBl.7X2.5BNi
Screw.
Remove OTL2196 Reflection absorber and
OTL2196
=
Se
PBL. 7X2.5 EE
:
TL2500
Governor can be removed.
Note. Insert guide into the part of
Upper arm of Transmission lever
assembly so that Lower arm can be
positioned rightly as shown in the
figure before assembling.
Guide
As to the adjusting method,
please refer to Note of page 22,