Installation
37
Carefully read the Assembly Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
5.4.2 Installing Generator
IMPORTANT!
There are a variety of generators (single or dual bearing generators) and resilient couplings
available on the market.
For this reason:
S Observe the installation instructions of the relevant manufacturer!
Flywheel
The interface dimensions of the flywheel are
indicated in the installation drawing.
Remove any oil, grease or conservation agents
from the fly wheel.
NOTE!
There are 2 different versions of the flywheel depending on the application. For example,
a supplementary centrifugal mass is required for speeds of 1500 rpm to improve the control
response.
Flywheel housing
The interface dimensions of the flywheel housing
are indicated in the installation drawing.
NOTE!
The flywheel housing has interface dimensions according to SAE1.
To Next Page
Loading...
