What to do if the gas flow blocks up the reading on my M&C ECM?
If the gas flow reading is blocked in your M&C Accessories, it might be due to contamination of the sample gas way. To resolve this, optimize the dust pre-separation upstream of the cooler. Additionally, ensure you clean the gas ways and the cooling system.
How to fix condensate in the gas outlet of M&C ECM?
If you observe condensate in the gas outlet of your M&C Accessories, take the following steps: * Heat up the components downstream. * Maintain operational data. * Consider changing the peristaltic pump or the tubing. * Clean the condenser fins and check the vent. * Ensure sufficient ventilation and check the safety distance from heated components. * Allow the cooler to cool down before restarting.
Why is the temperature wrong on my M&C ECM Accessories?
If the temperature is wrong with your M&C Accessories, check the PT100-sensor and the temperature controller. If the circuit of the cooling agent is leaky, send the cooler for repair.
Specifications for the ECM cooler without an integrated heat exchanger, including part numbers and key parameters.
Guidance on connecting sample gas inlet/outlet and condensate outlets using various connector types.
Step-by-step instructions for removing and installing heat exchangers, including thermal paste application.
General| Sensitivity | -38dB ±3dB (0dB=1V/Pa at 1kHz) |
|---|---|
| Impedance | ≤2.2kΩ |
| Operating Voltage | 1.5V - 10V DC |
| Current Consumption | ≤0.5mA |
| Type | Electret Condenser Microphone |
To Next Page
