M&R CHALLENGER II Series User Manual

081200MS
Recommended Lubricants
Quantity M&R Part No.
Description
1 Quart 7017000
10 Wt. Non-Detergent Oil
1 Tube 7018017
White Lithium Grease
1 Tube 7018031
Permatex Super Lube with Teflon
1 Quart 7017018
Vactra No. 4 Oil
Recommended Tools
Description
Combination Wrench Set (U.S. Standard)
1/4, 5/16, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8
Allen Wrench Set (U.S. Standard) 1/16, 5/64, 3/32, 7/64, 1/8, 9/64, 5/32, 3/16, 7/32, 1/4,
Allen Wrench Set (Metric) 1.5mm, 2mm, 2.5mm, 3mm, 4mm, 5mm
12” Adjustable Wrench
6” “C” Clamp
Locking Pliers (Vise Grip)
12” Pipe Wrench (Aluminum)
Electrical Pliers
Hammer 13” or Longer (Optional)
Rubber Mallet
Hack Saw (Optional)
1/2” Drive Ratchet Handle
1/2” Drive Socket Set (U.S.Standard) 3/8, 7/16, 1/2, 9/16, 5/8, 1/16, 3/4, 15/16, 1-5/16
Needle Nose Pliers
Measuring Tape Rule
Rat Tail File (Round)
5/16” Nut Driver
Screw Starter (Magnetic Type)
Utility Knife
Phillips Screw Driver 7” Long
Blade Screw Driver 7” Long
Flash Light
Wire Stripper/Solderless Terminal Crimper
9” Torpedo Level with Magnetic Strip
Small Phillips Screw Driver
Small Blade Screw Driver
Flat File (Coarse & Fine)
Snap Ring Pliers Int/Ext Rings
Volt/Ohm Meter (Multi-Tester)
Standard Pump Action Grease Gun
PREVENTIVE MAINTENANCE PROCEDURE
CHALLENGER Series II TOOLS/LUBE
63

M&R CHALLENGER II Series Specifications

General

Brand	M&R
Model	CHALLENGER II Series
Category	Industrial Equipment
Language	English