Manitou 170 AETJ L - Page 103

TILT ALARM
The platform is switched on. The platform is in transport position. The turntable, the basket and the jib (150AETJ3D
(150AETJC3D) are in neutral position. The jib is completely lowered.
- Open the right-hand turntable cover.
- Locate the leveling sensor.
- Press and hold the leveling sensor.
Result:
• The audible alarm should sound intermittently.
• The leveling sensor indicator lamp should go out.
- Release the leveling sensor.
Result:
• The audible alarm should stop.
• The leveling sensor indicator lamp should light up.
- Close the right-hand turntable cover.
OVERLOAD ALARM
The platform is switched on. The platform is in transport position. The turntable, the basket and the jib (150AETJ3D
(150AETJC3D) are in neutral position. The jib is completely lowered.
- Place a uniformly distributed load in the basket = between 220 kg and 250kg.
Result:
• The audible alarm should sound continuously.
• The overload alarm indicator lamp should flash.
- Try to activate all the functions one by one.
Result:
• It should not be possible to activate any of the functions.
- Remove between 20kg and 50kg to obtain a load of 200kg in the basket.
Result:
• The audible alarm should stop.
• The overload alarm indicator lamp should go out.
- Activate all the functions one by one.
Result:
• It should be possible to activate all the functions.
- Place the platform in transport position. Put the turntable, the basket and the jib (150AETJ3D (150AETJC3D)) in neutral
position. Level the basket. Lower the jib completely.
3 - 15
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L