SECOND VERSION
DRAIN THE OIL
- Clean the outside of the tank
1
with a clean cloth.
- Clean the outside of the hydrostatic return filter assembly
2
with a clean cloth.
- Locate the drain plug
3
and put a drain pan underneath.
- Remove the drain plug and the tank plug
4
.
- Wait until the tank is completely empty.
REPLACE THE HYDRAULIC RETURN FILTER CARTRIDGE
6
- Remove the cover of the hydraulic return filter
5
.
- Remove the used hydraulic return filter cartridge.
- Put the new hydraulic return filter cartridge in place, eFILTER CARTRIDGES.
- Put the hydraulic return filter cover back in place.
CLEAN THE SUCTION STRAINER
- Locate the hydraulic hose
7
and put a drain pan underneath.
- Remove the hydraulic hose, the union fitting and the suction strainer
8
.
- Clean the suction strainer with compressed air, from the inside out:
• Maximum pressure = 3 bars. Minimum distance = 30 mm.
- Check its condition. Replace it if necessary, eFILTER CARTRIDGES.
- Refit the suction strainer, the union fitting and the hydraulic hose.
FILL THE HYDRAULIC OIL TANK
- Refit the drain plug
3
.
- Fill the tank with new hydraulic oil, eLUBRICANTS. The level is correct when the
oil is between the MINI and MAXI marks.
- Refit the tank cap
4
.
- Switch the platform on. Activate the functions for 10 minutes.
- Check for leaks.
- Place the platform in transport position. Put the turntable, the basket and the jib
(150AETJ3D (150AETJC3D)) in neutral position. Lower the jib completely.
- Check the hydraulic oil level. Top up if necessary.
- Close the left-hand turntable cover.
- Turn the platform off.
CHECK Clearance of crown gear *
CHECK Condition of cylinders *
CHECK Condition of electric wiring *
RESET Maintenance warning
e50H-PERIODIC MAINTENANCE - EVERY 50 HOURS OF SERVICE OR 3 MONTHS
* Consult your dealer.
3 - 41
8
3
4
3
7
8
2
1
5
6
4
647536 (26/11/2020)
150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L