Manitou 170 AETJ L - Page 105

PLATFORM FUNCTIONS: BASKET TILTING
t
IMPORTANT
t
During the test, tilt the basket up/down slightly to avoid injury.
The platform is switched on. The platform is in transport position. The turntable, the basket and the jib (150AETJ3D
(150AETJC3D) are in neutral position. The jib is slightly raised.
NOTE:
• ORANGE FLASHING LIGHT option: The orange flashing light must light up when the functions are activated.
• ALL MOVEMENTS ALARM option: The horn must sound intermittently when the functions are activated.
- Do not press the control handle trigger. Try to activate the basket tilt up and down functions one after the other.
Result:
• It should not be possible to activate any of the functions.
- Press and hold down the trigger of the control handle.
- Activate the basket tilt up and down functions one after the other.
Result:
• It should be possible to activate the functions.
- Press and hold down the trigger of the control handle.
- Extend the telescope for 3 seconds.
Result:
• It should be possible to activate the function.
- Press and hold down the trigger of the control handle.
- Test the basket tilt up and down functions one after the other.
Result:
• Up to machine no. 950123: It should be possible to activate the functions.
• From machine no. 950124: It should not be possible to activate the functions.
- Fully retract the telescope.
- Level the basket.
- Lower the jib completely.
PLATFORM FUNCTIONS: MAIN ARM, SECONDARY ARM, TELESCOPE, JIB AND TURNTABLE ROTATION, BASKET ROTATION,
JIB ROTATION (150AETJ3D (150AETJC3D))
NOTE: Do not drive or steer the platform during this test.
The platform is switched on. The platform is in transport position. The turntable, the basket and the jib (150AETJ3D
(150AETJC3D)) are in neutral position. The jib is completely lowered.
NOTE:
• ORANGE FLASHING LIGHT option: The orange flashing light must light up when the functions are activated.
• ALL MOVEMENTS ALARM option: The horn must sound intermittently when the functions are activated.
- Do not press the control handle trigger. Try to activate all the functions one by one.
Result:
• It should not be possible to activate any of the functions.
- Press and hold down the trigger of the control handle.
- Activate all the functions one by one. Check that all the movements are complete up to the mechanical stops.
Result:
• It should be possible to activate all the functions.
• All the movements must operate correctly and smoothly.
• All the movements must be complete up to the mechanical stops.
- Place the platform in transport position. Put the turntable, the basket and the jib (150AETJ3D (150AETJC3D)) in neutral
position. Level the basket. Lower the jib completely.
3 - 17
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L