Manitou 170 AETJ L - Page 107

DRIVING ON A SLOPE AND TILT ALARM
The platform is switched on. The platform is in transport position. The turntable, the basket and the jib (150AETJ3D
(150AETJC3D)) are in neutral position. The jib is slightly raised.
TEST No. 1
- Select a slope between 15% (8.5°) and 20% (11.3°).
- Raise the jib to the horizontal position.
- Drive the platform forwards slowly on the slope, facing it, with the
basket at the bottom of the slope.
Result:
• The audible alarm should sound intermittently.
• The tilt alarm indicator lamp should flash.
- Brake the platform on the slope.
Result:
• The brakes should function properly.
• The platform should be immobilized on the slope for at least 1minute.
- Try to raise the main arm and the secondary arm and to extend the telescope.
Result:
• It should not be possible to activate the functions.
- Reverse slowly to drive the platform off the slope onto a level surface.
Result:
• The audible alarm should stop.
• The tilt alarm indicator lamp should go out.
- Brake the platform.
TEST No. 2
- Extend the telescope for three seconds.
- Drive the platform forwards slowly on the slope, facing it, with the basket at the bottom of the slope.
Result:
• The platform should brake automatically.
• The audible alarm should sound intermittently.
• The tilt alarm indicator lamp should flash.
- Try to raise the main arm and the secondary arm, to extend the telescope and to drive/steer.
Result:
• It should not be possible to activate the functions.
- Fully retract the telescope.
Result:
• It should be possible to activate the function.
- Reverse slowly to drive the platform off the slope onto a level surface.
Result:
• The audible alarm should stop.
• The tilt alarm indicator lamp should go out.
- Brake the platform.
- Lower the jib completely.
- Get out of the basket.
- Turn the ignition switch to position
. Turn the battery cut-off to the OFF position.
3 - 19
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L