Manitou 170 AETJ L - Page 75

FOLDED POSITION
B
:
NOTE: The platform is switched on. The platform is in the
transport position. The turntable and the basket
are in neutral position. The jib is in neutral position
(150AETJ3D (150AETJC3D)). The turntable is
locked.
- Lower the jib completely.
- Get out of the basket.
- From the ground control panel:
• Turn the basket to the left until it stops.
• Raise the main arm slightly.
• Tilt the basket fully downwards. Ensure that the
basket cannot hit the flatbed.
• Lower the main jib so that the basket is a distance of about 10 cm from the flatbed.
- Turn the platform off. Remove the key.
MOVE FROM THE FOLDED POSITION
B
TO THE TRANSPORT POSITION
A
:
NOTE: The turntable is locked.
- Switch the platform on.
- From the ground control panel:
• Raise the main arm slightly.
• Tilt the basket/jib upwards until the basket floor is horizontal. Ensure that the basket cannot hit the flatbed.
• Fully lower the main arm.
• Turn the basket to the right in the neutral position,
eOPERATING THE PLATFORM: TRANSPORT/WORKING POSITION.
- Turn the platform off.
CONFIGURE THE PLATFORM FOR TRANSPORT
t
IMPORTANT
t
Turntable rotation is prohibited once on the flatbed.
The turntable must be locked once on the flatbed, e SAFETY COMPONENTS: TURNTABLE LOCKING PIN.
The platform must be transported in TRANSPORT POSITION
A
or in FOLDED POSITION
B
.
TRANSPORT POSITION
A
:
NOTE: The platform is switched on. The platform is in the
transport position. The turntable and the basket
are in neutral position. The jib is in neutral position
(150AETJ3D (150AETJC3D)). The turntable is
locked.
- Lower the jib completely.
- Get out of the basket.
- Turn the platform off. Remove the key.
2 - 55
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L