27
MEZZER SERVICE MANUAL
Expert CASTING INSTALL
8
7
Thread the other lock-nut onto the
spring shaft adapter. Holding the
lock-nut with a 14mm box wrench,
use an 8mm socket tighten the
compression rod adapter to 35–40
in-lb [3.95–4.5 Nm] by turning
them counter-clockwise. Do not
overtighten, doing so can damage
the threads.
Install the rebound knob using a
2mm Hex wrench. Add a small drop
of blue Loctite to the screw before
installation to prevent the screw
from backing out during riding.
Note: Be sure to hold the knob
still while removing the screw. The
damper adjuster may be damaged
if the knob is over torqued.
To Next Page
Loading...
