28
MEZZER SERVICE MANUAL
Expert DAMPER Install
1
Fill damper leg about 3/4 full with
Maxima fork oil.
3
2
Install the axle into the fork
without a hub or wheel. Cover
the damper leg opening with a
lint-free towel. Using a wood
block or similar raised support
underneath the axle, compress
the fork 10-15 times.
With the fork fully extended add oil
to the height of 65mm measured
from the top of the stanchion.
NOTE: OIL HEIGHT IS SET WITH
FORK FULL EXTENDED AND
CASTING INSTALLED
The raised support should be wide
enough and long enough to safely
support the axle as well as tall enough
to eliminate contact between the oor
and the air cap or rebound knob. Do not
overtighten the axle bolt.
To Next Page
Loading...
