Need help?Do you have a question about the Manitou MARA PIGGYBACK and is the answer not in the manual?
General| Spring Type | Air |
|---|---|
| Damping | Hydraulic |
| Piggyback | Yes |
| Brand | Manitou |
| Material | Aluminum |
| Intended Use | Mountain |
| Adjustments | Rebound, Compression |
| Type | Rear |
| Model | MARA PIGGYBACK |
| Mounting Type | Trunnion |
Release air pressure and secure the shock in a vise.
Loosen, remove air can, bumper, spacers, and piston ring.
Fill damper tube, install shaft/piston, thread air piston, and perform initial bleed.
Fill compression assembly, bleed reservoir, set IFP depth, and reinstall bleed screw.
Torque end cap, pressurize IFP, test, install air can, and pressurize air can.
Controls the speed at which the wheel returns to sagged position after compression.
Controls damping for unsprung wheel movement like roots, rocks, and braking bumps.
Controls damping for sprung chassis movement, pedaling, and pumping.
Activates platform mode for more efficient climbing; selects between Party and Work modes.
To Next Page