34
MARA PIGGYBACK SERVICE MANUAL
16
Thread on the reservoir end
cap and torque to 5.6Nm
(50 in-lb) with the freewheel
removal tool (example: Park
Tool FR-1).
Pressurize the shock IFP to
300psi, test function in a hand
dyno.
17
18
Clean the air can, replace
negative spacers, apply grease
and install the air can while
easing the air piston back-up
rings into the air can. Place
the shock in a bike or on a
hand dyno, compress the
shock and thread on the air
can to a torque of 10.7Nm
(95in-lb).
Note: If compressing by hand it may be
necessary to release the gas charge to
ease the process.
bleed and fill
To Next Page
Loading...
