3 - 36
H6/5 H6/6
3
4
H6 - LIFT UP THE CABIN IN THE EVENT OF AN
ELECTRIC FAILURE
UP TO MACHINE N° : 117 315
ASSEMBLY OPTION
- Bring a floating battery of the same type as the one used for the lift truck
and battery cables.
- Open the inspection panel of motor 1 (Fig. H6/1).
- Access to the lift truck battery from the motor inspection panel and connect
the floating battery while respecting the polarity.
- Then, carry out the lifting of the cabin (See chapter : INSTRUMENTS AND
CONTROLS in paragraph : 2 - DESCRIPTION).
FROM MACHINE N
° : 117 316
- Bring a floating battery of the same type as the one used for the lift truck
and battery cables.
- Close the left door and open the right door of the cabin.
- Unlock the cabin with the lever 1 (Fig. H 6/2) in position A.
- Remove the key from the battery disconnecting device.
- Disassemble the panel 2 (Fig. H 6/3) to access to the connections of the
battery disconnecting device.
- Connect the negative cable onto the battery and take a good earth on the lift
truck (e.g. locking screw of the front axle on the frame) (Fig. H6/4).
- Connect the positive cable onto the battery and the terminal 3 (Fig. H 6/5) of
the battery disconnecting device.
- Turn on the ignition in the lift truck.
- Half-open the right door of the cabin and press the upper part of the switch 4
(Fig. H6/6) to tilt the cabin as far as possible without interfering with the
mast.
- Disconnect the positive cable from the terminal 3 (Fig. H6/5) of the battery
disconnecting device.
- Disconnect the earth in the lift truck.
- Access to the lift truck battery and connect the floating battery while
respecting the polarity (Fig. H 6/7).
- Then, carry out the lifting of the cabin (See chapter : INSTRUMENTS AND
CONTROLS in paragraph : 2 - DESCRIPTION).
H6/3
H6/4
1
H6/1
A
B
H6/2
1
2
To Next Page
Loading...
