EasyManuals Logo

Manitou MSI 40 User Manual

Manitou MSI 40
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
3 - 21
D3 - CHANGE THE DRY AIR FILTER CARTRIDGE
The air used to burn the fuel is purified by a dry air filter. It is therefore very
important that the lift truck should never be used with the cartridge removed
or damaged.
- Lift up the cabin (See chapter : INSTRUMENTS AND CONTROLS in
paragraph : 2 - DESCRIPTION).
UP TO MACHINE N° 142 126
- Unscrew nut 1 (Fig. D3/1) and remove cover 2 (Fig. D3/1).
- Unscrew nut 3 (Fig. D3/1) lift out and discard filter cartridge 4 (Fig. D3/1).
- Leave the safety cartridge in place.
- Clean the inside of the casing with a clean, damp lint free cloth.
- Refit the new cartridge and the cover.
In the event of the lift truck being used in a heavily dust laden atmosphere,
see chapter : FILTERS CARTRIDGES AND BELTS in paragraph : 3 -
MAINTENANCE.
FROM MACHINE N° 142 127
- Loosen the nuts and remove cover 1 (Fig. D3).
- Lift out and discard filter cartridge 2 (Fig. D3).
- Leave the safety cartridge in place.
- Clean the inside of the casing with a clean, damp lint free cloth. Also clean
the cartridge seal surfaces on the filter and cover.
- Then fit a new cartridge making sure it is in the correct position.
- Refit the cover, guiding the valve downwards.
In the event of the lift truck being used in a heavily dust laden atmosphere,
see chapter : FILTERS CARTRIDGES AND BELTS in paragraph : 3 -
MAINTENANCE.
D4 - CHANGE THE FUEL FILTER CARTRIDGE
- Lift up the cabin (See chapter : INSTRUMENTS AND CONTROLS in
paragraph : 2 - DESCRIPTION).
- Carefully clean the exterior of the filter and this bracket to prevent the dust
from entering the system.
- Unscrew locking screw 1 (Fig. D4).
- Remove tank 2 (Fig. D4) and discard cartridge 3 (Fig. D4) as well as the
seals of the cartridge.
- Clean the inside of the filter head and the tank, using a brush immersed in
clean diesel oil.
- Refit the assembly with a new cartridge and new seals.
If necessary, bleed the fuel circuit (See chapter : H1 - BLEED THE FUEL
SYSTEM in paragraph : 3 - MAINTENANCE).
D4
1
D3/1
1
2
3
4
D3/2
1
2
3
2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MSI 40 and is the answer not in the manual?

Manitou MSI 40 Specifications

General IconGeneral
BrandManitou
ModelMSI 40
CategoryForklifts
LanguageEnglish

Related product manuals