3 - 34
F8 – AIR CONDITIONING (OPTION)
CLEAN- CHECK
CLEANING CONDENSER AND EVAPORATOR COILS (*)
CLEANING CONDENSATE TRAY AND RELIEF VALVE (*)
COLLECTING COOLANT TO REPLACE FILTER-DRIER (*)
REFILLING WITH COOLANT AND CHECKING THE THERMOSTATIC CONTROL AND PRESSURE SWITCHES (*)
NOTE: When opening the evaporator unit, remember to replace the cover seal.
(*): (CONSULT YOUR DEALER).
IMPORTANT
DO NOT ATTEMPT TO REPAIR ANY FAULTS BY YOURSELF. ALWAYS REFER TO YOUR DEALER WHEN REFILLING CIRCUITS, AS THEY HOLD THE CORRECT SPARE PARTS, ASWELL
AS HAVING THE NECESSARY TECHNICAL KNOWLEDGE AND TOOLS.
In the event of inhalation, take the victim into fresh air, give oxygen or artificial respiration if necessary and call a doctor.
In the event of contact with the skin, wash immediately with copious amounts of water and remove any contaminated garments.
In the event of contact with the eyes, rinse with clear water for 15 minutes and call a doctor.
- Do not open the circuit under any circumstances as this would loss of coolant.
- The cooling circuit contains a gas which can be dangerous under certain conditions. This gas, coolant R-134a, is colorless,
odorless and heavier than air.
- The compressor has a fluid level gauge; never unscrew this gauge because it would
depressurise the system. The fluid level should only be checked when draining
the system.
647563 (22/08/2017)
MT 1435/1440/1840 EASY 75D ST3B S1
To Next Page
Loading...
Need help?
General
