Manitowoc convotherm 4 - Specific Cleaning Instructions; Working Safely During Cleaning

3 Replacing appliance parts to rectify problems
Repair Manual C4 111
3.8.4 Removing and fitting the core temperature probe
Component
Name Part number
Core temperature probe #######
Tools required
 7 mm / 13 mm open-ended wrench
 24 mm offset box wrench
 or 24 mm socket wrench (recommended)
Requirements
Check that the following requirements have been met:
 The appliance has been disconnected from the power supply and protective measures taken to
ensure the power cannot be switched on again.
 The left-hand side panel has been removed.
 The oven has cooled down.
Removing and fitting the core temperature probe
1.
Disconnect the probe (X4) from the SI board.
2.
Hinge the right-hand rack into the cooking chamber.