3 Replacing appliance parts to rectify problems
Repair Manual C4 93
3.6.6 Removing and fitting the water-level probe (electrical appliance)
Component
Name Part number
Water-level probe (4B12) 5056348
Tools required
10mm open-ended wrench
Phillips screwdriver
Requirements
Check that the following requirements have been met:
The appliance has been disconnected from the power supply and protective measures taken to
ensure the power cannot be switched on again.
The left-hand side panel has been removed.
Removing the water-level probe
1. Use a screwdriver to undo the screws on the terminal blocks for
the red and blue cables.
2.
Undo the three screws (M6) on the water-level probe using a
10mm open-ended wrench.
To Next Page
Loading...
