3 Replacing appliance parts to rectify problems
Repair Manual C4 154
3.16.1 Removing and fitting the convection burner fan
Component
XXX convection burner fan
Tools required
9mm socket wrench
9mm box wrench
8mm open-ended wrench
Screwdriver
Requirements
Check that the following requirements have been met:
The appliance has been disconnected from the power supply and protective measures taken to
ensure the power cannot be switched on again.
The left-hand side panel has been removed.
The gas supply has been shut off.
Removing the convection burner fan
1. Remove the automatic firing devices and take off all the con-
nectors.
2.
Use a 9mm box wrench to remove the pressure governor.
3.
Use a screwdriver to lift out the retaining bracket.
To Next Page
Loading...
