3 Replacing appliance parts to rectify problems
Repair Manual C4 155
4.
Undo the retaining screw using an 8mm open-ended wrench.
5. Use a 9mm socket wrench to completely unscrew the two
left-hand screws.
Loosen the two right-hand screws.
6.
Remove the convection burner fan.
Fitting the convection burner fan
Follow the steps in the reverse order to fit the convection burner fan.
Before fitting, replace the old set of gaskets with a new set.
1.
Remove the two right-hand screws and the old gaskets.
2.
Fit the new set of gaskets.
3.
Now start to fit the burner fan.
4.
After fitting the burner fan, make sure that the installation is
gas-tight.
To Next Page
Loading...
