EasyManua.ls Logo

Manitowoc convotherm 4 - Page 18

Manitowoc convotherm 4
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 For your safety
Repair Manual C4 16
Safety hazard: heat
Danger Where or in what situations does the
hazard arise?
Preventive action
Risk of fire from heat given
off by the appliance
If flammable materials, gases or liquids
are stored near or on the appliance.
Do not store flammable materials, gases
or liquids beside or on top of the appli-
ance.
A risk of burns from hot
surfaces
Outside of appliance door
Before starting servicing and repair work,
wait until the cooking chamber has
cooled to below 60°C or use the
Cool-Down function to cool the cooking
chamber
Wear specified protective clothing, in
particular protective gloves
Inside the entire cooking chamber,
including all parts that are inside during
cooking, such as
Racks
Suction panel
Core temperature probe
Shelf-grills etc.
On the inside of the appliance door
On the transport trolley
On the loading trolley
On the top of the appliance:
Air vent
Exhaust outlet
Ventilation port
Risk of scalding from hot
steam if water is sprayed
into the hot cooking
chamber
In the entire cooking chamber
Before starting servicing and repair work,
wait until the cooking chamber has
cooled to below 60°C or use the
Cool-Down function to cool the cooking
chamber
Wear specified protective clothing, in
particular protective gloves
Safety hazard: mechanical parts of the appliance
Danger Where or in what situations does the
hazard arise?
Preventive action
Risk of hand injuries from
rotating fans
In the cooking chamber behind the
suction panel
In wiring compartment
Disconnect power supply before re-
moving the suction panel
Disconnect power supply before re-
moving the cover
Risk of body parts being
crushed if the appliance tips
over or falls off
When the appliance is being moved e.g. to
gain better access to the connections
Always observe the requirements for the
supporting surface; see Requirements for
the installation site in the chapter ‘Setting
up the appliance’ in the Installation manual
Gefahr einer Schnittverlet-
zung durch scharfe Kanten
Beim Hantieren mit Blechteilen
Bei diesen Tätigkeiten Vorsicht walten
lassen
Persönliche Schutzausrüstung tragen
Risk of hands being
pinched
When wheeling in transport trolleys or
loading trolleys
Always use the loading trolley handle
when moving transport trolleys or loading
trolleys

Table of Contents

Other manuals for Manitowoc convotherm 4