2 For your safety
Repair Manual C4 19
Item Safety device Function Check
ance door
heating
7
(no picture)
Safety thermostat
Boiler
Cooking chamber
Switches off the appliance if
temperature too high
Test is a software function
8
(no picture)
Magnetic door switch:
Electric door sensor for
appliance door
Switches off the fan and heater
when the appliance door is
opened, so that the fan stops
rotating within a few seconds
Check magnetic door switch at low
temperature:
Action:
Open the appliance door fully
Press Start
Result:
Motor must not start up
9
(no picture)
Forced rinsing after power
failure in case cleaning
agent was left in the
appliance
Re-starts the ConvoClean /
ConvoClean+ fully automatic oven
cleaning process in a defined state
after power failure
This test is a software function.
There is no need for the user to
perform a test
10
(no picture)
Spray-guard
Stops distribution of the cleaning
fluid during the ConvoClean /
ConvoClean+ fully automatic
oven cleaning process if the
appliance door is opened
Prompt to close the appliance
door
Test is a software function
11
(installed by
customer)
Disconnection device
Installed by the customer close to
the appliance; easily visible and
accessible, 3-pole action, mini-
mum contact separation 3 mm.
Used to disconnect the appliance
from the power supply during
cleaning, repair and servicing work
and in case of danger
Action:
Trip the disconnection device
Check at the X10 terminal strip on
the appliance that none of the
three phases carry a live voltage
12
(installed by
customer)
For gas appliances:
gas shut-off device
Installed by customer close to
appliance in easily accessible
position and clearly labeled.
Used to disconnect the appliance
from the gas supply during clean-
ing, repair and servicing work and
in case of danger
Action:
Close gas shut-off device
Check that the appliance is
isolated from the gas supply
To Next Page
Loading...
