3 Replacing appliance parts to rectify problems
Repair Manual C4 96
3. Undo the three screws (M6) on the water-level probe using an
open-ended wrench (10mm).
4.
Remove the water-level probe.
Fitting the water-level probe
Follow the steps in the reverse order to fit the water-level probe.
1. Make sure you connect the two cables to the correct terminal
when wiring up the water-level probe.
bl = blue
rd = red
2.
After fitting the water-level probe, make sure that the installation is
watertight.
To Next Page
Loading...
